View Single Post
Old March 17, 2013, 07:48 AM   #7
TechAlG
Junior Member
 
Join Date: May 14, 2007
Posts: 3
I've accidentally loaded some 9mm Mak brass as 9 Luger. The sizing die seemed to size them down just fine. Only reason I noticed it was because it appeared the bullet was too far out of the case. After doing the thinking about whether it would blow my gun up, I tried it. It fed well, and shot normal.

Would I recommend doing it? No. Does it work in 9mm Luger? Sure.
TechAlG is offline  
 
Page generated in 0.05268 seconds with 7 queries