View Single Post
Old March 15, 2013, 08:47 AM   #30
Senior Member
Join Date: January 28, 2013
Location: Land of 10,000 taxes
Posts: 208
I didn't throughly read all the replys to you question, but I didn't see any suggestions to re-set the dies. I had similar symptoms and did the whole die cleaning/de-burring process. (Brillo pad wrapped around a small caliber bronze brush on a cordless drill). Slight improvment but didn't solve the problem. I finally reset the dies and made sure they were true to the stroke of the ram (Dillon press). No more Scatches.

Good luck
Dad !!! "It's only going to be perfect if you do it yourself." - my teenage daughter
Dad !!! "I'm not scared" My Cancer fighting daughter."
Cancer Sucks
NRA - Life Member
mjes92 is offline  
Page generated in 0.03400 seconds with 7 queries