View Single Post
Old March 14, 2013, 05:48 PM   #4
cvbinrichmond
Junior Member
 
Join Date: June 28, 2011
Posts: 5
Sorry for the wrong terminalogy. My point was that the "bullet" in the new batch would slide into the "case" but the case had been sized properly with the old batch of bullets. My question was, is 1 one thousand of an in. enough to cause this. If not, then the two batches of bullets must be of a different diam. I would appreciate your thoughts on this.
cvbinrichmond is offline  
 
Page generated in 0.04220 seconds with 7 queries