View Single Post
Old March 14, 2013, 05:21 PM   #10
PA-Joe
Senior Member
 
Join Date: June 9, 2010
Location: NEPA
Posts: 740
You must have misread the instructions. Raise the ram with the shellholder in place and screw the die down until it toughes. The lower the ram and screw the die in another 1/4 turn to lower it. By backing off you are not allowing the dies to fully resize the case. Another thing you can do is keep turning it in 1/4 turn until the cases fit into the chamber. This way you are not over sizing the shoulders. There is nothing wrong with your die.
PA-Joe is offline  
 
Page generated in 0.04850 seconds with 7 queries