View Single Post
Old March 14, 2013, 03:49 PM   #10
johnm1
Senior Member
 
Join Date: November 26, 2006
Location: Mesa, AZ
Posts: 382
Thanks MWM. I wasn't sure if I had the wrong extractor or not. It appears that what i am experiencing is normal.

I would take any load information that you have on both .32 S&W and .38 S&W as I have both.

You wouldn't know of a source for a pivot nut for a .38 Double Action (third model, but I don't think the model matters). this is the screw looking nut that holds the sideplate on. My .38 Double Action came without and I'd rather not try to fabriate one if I can avoid it. Numrich is out of the nut. They have the pivot stud, but not the nut.
__________________
John M.
Mesa, AZ
johnm1 is offline  
 
Page generated in 0.05587 seconds with 7 queries