View Single Post
Old March 14, 2013, 10:17 AM   #4
RCP Fab
Senior Member
 
Join Date: February 22, 2013
Posts: 102
I should have measured before I posted.

The lee instructions state to bottom the die then TIGHTEN 1/4-1/3 turn. Right now, with press flex it bottoms out fully.

Now to find a headspace gauge in stock...

Last edited by RCP Fab; March 14, 2013 at 10:22 AM.
RCP Fab is offline  
 
Page generated in 0.04048 seconds with 7 queries