View Single Post
Old March 14, 2013, 09:14 AM   #1
RCP Fab
Senior Member
 
Join Date: February 22, 2013
Posts: 102
Full length resizing die question. Picture.

I am getting a crisp line, about 1/16" above the top of the taper of case after resizing. It it's just a mark, I can not feel it with my fingernail. The die was bottomed out to the ram, and tightened 1/4 turn, should it be brought lower than this?

Thanks


Last edited by RCP Fab; March 14, 2013 at 05:33 PM.
RCP Fab is offline  
 
Page generated in 0.04079 seconds with 7 queries