View Single Post
Old March 12, 2013, 11:09 PM   #15
cdbeagle
Senior Member
 
Join Date: January 3, 2012
Location: Justin Texas
Posts: 280
Quote:
Damzur is right,c get your self a 5/16-36 tap ( special thread you will have to buy it from a machine tool supplier, I got mine on-line) and the correct drill size for the tap. Its easy to do. I full length size my case and then take my dremel tool and a fine cutting wheel and cut a slot in the case neck down to the start of the shoiulder. the tension is perfect. You may have to de-burr the edge with a small file. You can make any number of modified cases when you need them.
IMHO all reloading benchs should have a dremel tool on it. I would be lost and hamstrung without mine.
I will try this method. I do have a dremel tool.
__________________
I comprehend how a projectile can, “lose velocity", but don't understand how a projectile can, "loose velocity".
cdbeagle is offline  
 
Page generated in 0.04831 seconds with 7 queries