Thread: 1917 eddystone
View Single Post
Old March 10, 2013, 11:16 AM   #10
Senior Member
Join Date: September 19, 2008
Posts: 4,679
B-Square makes a scope mount & rings for the 1917 Enfield, including the Eddystone.

Looking at the buyer comments/reviews, and thinking about the 1917 rifles, I would think additional mount screws are needed, and that the receiver & bridge needs to be spot annealed before any D/T, due to the exceptional hardness.

If the B-Square base doesn't already have mounting a screw hole just ahead of where it passes over the hole in the bridge, it'd most likely possible to drill new holes in the required location.

PetahW is offline  
Page generated in 0.04294 seconds with 7 queries