View Single Post
Old March 6, 2013, 09:11 PM   #12
Creek Henry
Senior Member
 
Join Date: October 23, 2009
Location: Dallas
Posts: 296
I actually have to congratulate myself for one thing I did do right. I ordered 2 of those tiny, little clips.

When I was tyring to install the first one, it just would not go on. After about an hour of trying, sure enough, it went flying off and I couldnt' find it.

So, I got the 2nd one out, tied some string to it and had at it again. It finally went in to place. I'll make sure it stays there after a round of clays but it should be fine. If not, I'll do soemthing more drastic to keep that pin in place.
Creek Henry is offline  
 
Page generated in 0.04925 seconds with 7 queries