View Single Post
Old March 1, 2013, 04:37 PM   #5
Panfisher
Senior Member
 
Join Date: July 30, 2010
Location: Missouri
Posts: 722
I went through the desire to "build" a 10/22, purchased an Adams & Bennet .920 target barrel and used my factory wood stock I believe the final recipe was a 3/4 PVC pipe wrapped in sandpaper to open up the barrell channel sufficiently. I ended up bedding the barrel to the stock near the end of the forearm section with some liquid steel / JB weld type stuff. Stained the wood stock and shot a coat of Poly over it. Shot and worked fine, just finally got to the point where I enjoyed the original configuration better. Purchased a factory takeoff stock on Rimfire central and returned it to is original. Still have the barrell and stock sitting in a corner maybe some day I'll put it back on for a while.
Panfisher is offline  
 
Page generated in 0.05401 seconds with 7 queries