View Single Post
Old February 22, 2013, 06:37 PM   #8
reynolds357
Senior Member
 
Join Date: December 10, 2012
Posts: 2,543
Right now I am working on necking a 7WSM down to 6mm. I know it has already been done, but I am trying to push the shoulder as far as possible and am planning on using a tremendous amount of freebore. The only thing holding me up at the moment is the barrel maker I am using is balking at the gain twist rate I am asking for. If all goes as planned it should push 4600FPS.
reynolds357 is offline  
 
Page generated in 0.04897 seconds with 7 queries