View Single Post
Old February 22, 2013, 06:10 PM   #3
bigedjr
Junior Member
 
Join Date: February 22, 2013
Posts: 7
Some more info.

Thanks so much, I'm checking on the Mauser.
I read that the large ring Mauser trigger guard screw holes, From center hole to center of other hole should measure about 7 7/8 or 7.830. This one is approx. 6.50.
33 1/4" LONG
Measures by back swivel: 2" WIDE
BY NOSE: 2 1/2"
BARREL CHANNEL: 1 1/4"
FROM REAR SCREW HOLE TO END OF BARREL END / NOSE: 20 1/4"

I would really appreciate any help, I have researched this till my head is about to burst!
Attached Images
File Type: jpg target2.jpg (149.7 KB, 29 views)
File Type: jpg target3.JPG (1.3 KB, 25 views)
File Type: jpg target4.jpg (203.8 KB, 22 views)
bigedjr is offline  
 
Page generated in 0.04667 seconds with 8 queries