View Single Post
Old February 21, 2013, 09:20 PM   #2
Ridge_Runner_5
Senior Member
 
Join Date: February 8, 2008
Location: Denver, CO
Posts: 1,879
I bought one a while back for my M1A. The instructions say you need to set it in place on the grooves, put the nut in about hand tight, and then hit the ends back and forth with a rubber mallet so that the aluminum mount forms to the receiver and matches with it, creating a solid mount.

I didn't like the big gap in the middle, though. So I tossed mine out (not good for resale by itself after it's been fitted) and went with an aluminum Sadlak instead.
Ridge_Runner_5 is offline  
 
Page generated in 0.04084 seconds with 7 queries