View Single Post
Old February 20, 2013, 03:58 PM   #9
Wallyl
Senior Member
 
Join Date: September 8, 2011
Posts: 148
Lee Mold galling

I use a small candle on the sprew plate screw. After so many casts, with bullets in eth mold--touch it lightly to the top of the sprew plate screw..it gives enough to last quite awhile and it will not contaminate the cavities.

I will try some syn oil next time with mine. Syn oil doesn't breakdown under high temperatures... With the candle wax, it will evaporate without leaving a residue, so you have to replenish it, after so many casting cycles. No big deal IMHO.
Wallyl is offline  
 
Page generated in 0.04442 seconds with 7 queries