View Single Post
Old February 20, 2013, 01:08 PM   #8
Senior Member
Join Date: January 10, 2011
Location: Leesville SC
Posts: 1,184
Thanks for all the replies Gentlemen! I will remember the 2cycle oil Idea for the new mold. I'm going to contact Lee today and see what they say. I have put the locating pin back in and cleaned it up. But I can't do anything about the machining mark (makes that side of the ball look like a cut sprue) in one side of the cavities.
"You're so drunk you cant hit nothin, In fact you're probably seeing double"...."I have TWO GUNS one for each of ya"
deerslayer303 is offline  
Page generated in 0.04176 seconds with 7 queries