View Single Post
Old February 17, 2013, 06:50 PM   #3
AR15barrels
Member
 
Join Date: August 23, 2006
Location: Los Angeles, CA
Posts: 53
Remington 700 .223 chambering reloads problem

Sounds like the brass is not getting sized enough.
Continue turning the die into the press until the bolt will close on it.

Wrap a piece of masking tape around your die.
Make marks on the tape every 1mm.
As you turn the die down, each time you pass a 1mm tick mark, you have adjusted the die down another 0.001".
Make small adjustments, perhaps 0.002" at a time while checking for proper fit of the sized cases in the gun until you get to the right adjustment.
AR15barrels is offline  
 
Page generated in 0.04085 seconds with 7 queries