View Single Post
Old February 17, 2013, 10:33 AM   #1
Senior Member
Join Date: July 15, 2006
Location: Fern Creek ,KY and Metro Louisville at large
Posts: 329
A few problem holes

A couple of screw holes completely into a shotgun chamber.
This is a card shoot gun with a 48 inch custom barrel.
The owner won in a side bet.

The gun had the brass piece as some form of riser or a cover up

Customer wants to have a scope mounted to use.

Any ideas?
I was thinking of soldering the brass piece back on with soft solder and fitting long screws to fill the holes and machine flush with chamber.
CW Shooters Supply Inc
Machine Shop and Finishing Services to the trade and public
guncrank is offline  
Page generated in 0.03475 seconds with 7 queries