View Single Post
Old February 14, 2013, 09:57 AM   #13
eldermike
Senior Member
 
Join Date: January 24, 2013
Location: NC
Posts: 545
Recieved the new stock (sorry about the poor cell phone quality picture).

Had to do a bit of work on the inside of the stock to get the reciever to sit on the alloy block. Just some light sanding to remove some overhand of the finish. When I first put the action into the stock it was way off center of the barrel channel but that was mostly fixed by cleaning it up. It's still not perfect but close enough and fully floating. I will shoot it before I decide on skim bedding. Right now I doubt it needs it just based on the way the screws torque down.

Got a 2 1/2 lb timney trigger due in tomorrow.
Attached Images
File Type: jpg new stock.jpg (173.4 KB, 14 views)
eldermike is offline  
 
Page generated in 0.05040 seconds with 8 queries