View Single Post
Old February 13, 2013, 08:27 PM   #1
davery25
Senior Member
 
Join Date: October 4, 2011
Location: Australia
Posts: 300
Full length sizing without shoulder setback

Hi guys,

I have a k-31 swiss that i'm having trouble reloading for. I have redding FL dies and if i set it up to only set the shoulder back 0.002, the entire case isn't taken in by the die and much of the case web is left unsized. The 7.5x55 is highly tapered and that's cause difficult in chambering the cases.

Yes i have checked brass length.

If i size the entire case the shoulder gets set back 0.006 to 0.007 which is way too much.

is there some way to size the entire case while only setting the shoulder back 0.002?

Cheers in advance
davery25 is offline  
 
Page generated in 0.04678 seconds with 7 queries