Thread: loose bullets
View Single Post
Old February 13, 2013, 08:12 PM   #13
dickttx
Senior Member
 
Join Date: May 29, 2011
Location: Fort Worth
Posts: 494
As M&P said, make sure your sizing die is set correctly, then run a case through that die only. If you can insert the bullet in the sized case by hand, even with a lot of pressure, your sizing die is not sizing small enough. If it is a new set of dies I would call Lee and they would probably replace your sizing die.
I have two sets of Lee 38 Super dies and one set of RCBS and none of them will size my cases small enough to retain a FMJ, .355 bullet.
__________________
Education teaches you the rules, experience teaches you the exceptions (Plagiarized from Claude Clay)
dickttx is offline  
 
Page generated in 0.04074 seconds with 7 queries