View Single Post
Old February 12, 2013, 10:20 AM   #4
madcratebuilder
Senior Member
 
Join Date: November 2, 2007
Location: Northern Orygun
Posts: 4,868
The heat needed (1200*) for silver solder can discolor the finish on the barrel and FH.

I use old 1/16 drill bits as a pin. I drill about .090 into the barrel, the top of the pin is about 1/16 below the surface. TIG it then dress with a file, touch up with a B/C Super Black paint pen. It's invisible. I do use a crush washer for clocking and torquing before I drill and pin.
madcratebuilder is offline  
 
Page generated in 0.06051 seconds with 7 queries