View Single Post
Old February 11, 2013, 09:02 PM   #8
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,679
Please forgive a stoopid question: Did you just remove the forend wood, leaving the foorend iron attached to the barrels, or did you unsnap the entire forend assembly off the barrelled action ?

Once the forend's off, along with the attached forend iron, there's nothing that should stop one from unhooking the barrel set from the action hinge pin when the top/opening lever's held in the "open" position.


.
PetahW is offline  
 
Page generated in 0.04869 seconds with 7 queries