View Single Post
Old February 10, 2013, 10:13 PM   #8
Orphanedcowboy
Senior Member
 
Join Date: April 16, 2009
Location: Fort Worth, Texas
Posts: 193
Yes, the spring in there will last for yrs, trust me. You are not getting better quality on it just because it has some one else's name on it.

The only reason to swap would be if you wanted to modify the magazine capacity.

Then, you will see that those aftermarket springs with the end not properly crimped/curled cause more problems than the factory spring. The factory is square, they just cut the aftermarkets wherever and they cause feed issues. The follower tilts and binds if you don't square up the new spring:

Aftermarket:



Factory:

__________________
NRA Life Member
Orphanedcowboy is offline  
 
Page generated in 0.04147 seconds with 7 queries