View Single Post
Old February 10, 2013, 08:30 PM   #2
1stmar
Senior Member
 
Join Date: March 21, 2012
Location: Connecticut
Posts: 1,263
You can salvage the components if you have a bullet puller. You can gt one from midway for less then 20$, kinetic puller works fine. I don't have a square deal, but it sounds like you are not seating the primers firmly enough. On the 550b this occurs on the up stroke as the ram lowers the shell plate. I would start there. It may be possible your shell plate is not tightened down enough. Pure speculation on that since I don't have a square deal
1stmar is offline  
 
Page generated in 0.04243 seconds with 7 queries