View Single Post
Old February 9, 2013, 02:07 PM   #1
rep1954
Senior Member
 
Join Date: July 5, 2009
Location: Mid Western Michigan
Posts: 737
What Diameter and How Deep?

I'm going to be doing a pin and weld job on a 11 1/2" barrel and a 5 1/2" flash hider for the first time and need to know what diameter I should use for the pin and how deep must it enter the barrel? Is a high speed or cobalt pin okay for this or should I use something else? Should a crush ring be used?
rep1954 is offline  
 
Page generated in 0.05993 seconds with 8 queries