View Single Post
Old February 8, 2013, 10:07 PM   #7
barnbwt
Senior Member
 
Join Date: May 17, 2012
Posts: 680
Saw this and thought some diagrams I made earlier for my M90 build were pertinent:


I missed the safety detent-pin and spring. They're tiny, and sit on the left side of the trigger plate above the safety in a tiny little hole--don't lose them when you pop out the safety! Oh, and my 1976 has a bolt with a square head for some stupid reason. Luckily I managed to find a metric socket that grabbed enough to break it loose.

I'm no gunsmith, so my terminology is bogus, but hopefully these will help you out. It's always a good idea to document dissassemblies like this with photos to help retrace your steps

Here's the build so far (and my 700 SPS destined for a FAL magazine); got the dummy-stock inletted for the modified trigger/bolt release controls:


TCB
__________________
"I don't believe that the men of the distant past were any wiser than we are today. But it does seem that their science and technology were able to accomplish much grander things."
-- Alex Rosewater

Last edited by barnbwt; February 8, 2013 at 10:26 PM.
barnbwt is offline  
 
Page generated in 0.04561 seconds with 7 queries