Thread: rusty woes
View Single Post
Old February 7, 2013, 07:01 PM   #8
Hawg Haggen
Senior Member
 
Join Date: September 8, 2007
Location: Mississippi
Posts: 11,639
If you're using a slotted jag to clean with throw it away. Use a patch jag that gives you a tight fit in the bore. Forget the foaming crap and use hot soapy water. After it drains a few minutes spray it out with WD-40 and run a light coat of Bore Butter or vegetable oil in it. Just make sure if you use a petroleum based oil in the bore to wash it out before you load it. Petro lubes and bp fouling don't like each other.
Hawg Haggen is offline  
 
Page generated in 0.06589 seconds with 7 queries