View Single Post
Old February 7, 2013, 02:07 AM   #5
iraiam
Senior Member
 
Join Date: September 6, 2012
Location: Lakewood, CO
Posts: 872
Yes, I have a setup similar to the one pictured, my mill is smaller but I can and have changed an FSB that was un-drilled and used the existing taper pin grooves on the barrel.

I won't have to take any of this work to a gunsmith, as I have all the necessary machine and tooling at home, at least everything I need except time that is.
__________________
NRA Lifetime Member Since 1999

"I ask, sir, what is the militia? It is the whole people except for a few public officials." George Mason
iraiam is offline  
 
Page generated in 0.04375 seconds with 7 queries