View Single Post
Old February 6, 2013, 09:12 PM   #13
AR15barrels
Member
 
Join Date: August 23, 2006
Location: Los Angeles, CA
Posts: 53
Quote:
I do about the same thing but I take a little off the break instead of the barrel as its easier to get in the lathe. I make most of my breaks and leave a little thread releif so I can fit it to the barrel.
That works good when the brake is the same size as the barrel.
On muzzle devices that exceed the barrel diameter and have a finish on them, I prefer to trim the barrel shoulder so as not to leave unfinished metal on the back side of the muzzle device or remove the nicely rounded edges that may be present.
AR15barrels is offline  
 
Page generated in 0.04765 seconds with 7 queries