View Single Post
Old February 6, 2013, 02:11 PM   #44
AR15barrels
Member
 
Join Date: August 23, 2006
Location: Los Angeles, CA
Posts: 53
Quote:
Unfortunately the barrels are made right at 16", so rechambering isn't an option.
I know I'm late to the party and I like how you fixed the problem, but you could also probably have set the barrel back an inch and then threaded the muzzle and permanent attached something to get you back to length.

Did you clock the sleeve so that the barrel will time up properly, or did you just end up timing the barrel afterwards?
AR15barrels is offline  
 
Page generated in 0.03436 seconds with 7 queries