Thread: Sliding a Safe
View Single Post
Old February 4, 2013, 10:16 AM   #32
RonR6
Senior Member
 
Join Date: February 2, 2013
Location: South Eastern PA
Posts: 108
Wedge a wood shim under safe and lift with a flat
bar raise one corner at a time, just enough to get
a small craftsman socket underneath. Repeat other
corners and roll away. If moving long distances replace
A socket as needed. I have done this many times
If floor is finished you need 1/8 inch steel plate strips
Good luck
RonR6 is offline  
 
Page generated in 0.04154 seconds with 7 queries