View Single Post
Old February 3, 2013, 11:13 AM   #5
testuser
Senior Member
 
Join Date: September 8, 2010
Posts: 495
If the bullet is oversized, then I refrain from using my Lee Factory Crimp die. It tends to swage the bullet down. I just give them a really light taper crimp, usually crimping and seating in the same step.

You'll have to experiment with the load. I find starting loads or just above starting loads for jacketed data works best for many calibers, but you'll probably want to start with lead data and definitely not exceed mid range jacketed data.
testuser is offline  
 
Page generated in 0.04290 seconds with 7 queries