View Single Post
Old February 2, 2013, 10:37 AM   #8
chiefr
Senior Member
 
Join Date: January 27, 2010
Location: AR
Posts: 1,225
Continued from my first post.
I see some have experienced the same problem with the capsules sliding out of the cases.
The only way I could keep the capsules in place was a very heavy crip. I used RCBS dies because I could get a tighter crimp. I even pre tested my crimps with a kinetic bullet puller before I firing in a revolver.
It was a PITA to get the die adjusted and once I did I loaded quite large batch of them because I did not want to go thru the ordeal of adjusting the die again when I reverted back to regular bullets.
I always liked the 44cal capsule because you could get much more shot inside.
If you are shooting a TC, crimp is not a factor.
chiefr is offline  
 
Page generated in 0.04206 seconds with 7 queries