View Single Post
Old February 2, 2013, 03:34 AM   #15
10 Spot Terminator
Senior Member
 
Join Date: January 3, 2008
Location: Central Oregon
Posts: 346
I have used the hollow pointing bits quite a bit on my Forster case trimmer with good results. The chuck squeezes the rim of the case snuggly and presents no problem . Would like to see that setup for a drill press as well to allow use of different bits other than the 2 only available by Forster.
10 Spot Terminator is offline  
 
Page generated in 0.04107 seconds with 7 queries