View Single Post
Old February 2, 2013, 01:31 AM   #22
bamaranger
Senior Member
 
Join Date: October 9, 2009
Location: North Alabama
Posts: 4,264
Break Free-bore cleaning foam

I've become a big fan of the foams, the one above currenty, cause its available locally.

I clean the bore as per usual with std Hoppe's and brush and patches. Then I do a foam treatment, letting the rifle set 10-15 minutes. You will not believe what comes out of the rifle! I swab again, then do an overnight foam treatment, swabbing with Hoppes as a last step.

I could not get Hoppe's Copper to cut my ADL's fouling problem, and using it after a match on F-T/R rifle was a lot of work too. The foam has eliminated a lot of scrubbing!

Ran some foam through an old Garand........good grief!
bamaranger is offline  
 
Page generated in 0.04578 seconds with 7 queries