View Single Post
Old February 1, 2013, 04:39 PM   #4
Doyle
Senior Member
 
Join Date: June 20, 2007
Location: Starkville, MS
Posts: 4,978
Unlike a rifle where getting taller than required rings interferes with your check-to-stock weld, taller rings on a handgun really don't affect anything. They do, however, allow you to get your thumb underneath the scope bell to pull the hammer back. I don't know about your XVR, but on an Encore pistol that scope to hammer gap can get kind of tight for your thumb.
Doyle is online now  
 
Page generated in 0.04367 seconds with 7 queries