View Single Post
Old January 31, 2013, 02:36 PM   #3
RickB
Senior Member
 
Join Date: March 1, 2000
Location: Western WA
Posts: 5,862
Trimming .38 Super sounds like the best way to go, as you'll never have to worry about running out.
I made brass for a 9mm Japanese revolver by trimming .38 Super, which required trimming off only 1mm, but I still had to inside-ream the cases to seat .357" bullets. It was a bit of a hassle, but after I had 50 useable cases, I didn't think I'd have to make any more.
RickB is offline  
 
Page generated in 0.04741 seconds with 7 queries