View Single Post
Old January 30, 2013, 10:53 PM   #18
CTS
Senior Member
 
Join Date: November 6, 2011
Location: NE Georgia
Posts: 1,070
I have one that is hard to remove and one that is not. The one I have a problem with is an aftermarket mag. It has a black plastic floor plate that say's Eaton. It is apparently a Mark II mag since it holds 10 rounds. If your mag is catching after it comes about 1/2" out, look for a sharp edge on the mag release. This tends to hang in the magazine where it transitions from floor plate to sheet metal. I took a file to my magazine release and filed the sharp edge off and no longer have a problem.
CTS is offline  
 
Page generated in 0.05338 seconds with 7 queries