View Single Post
Old January 30, 2013, 12:20 PM   #8
F. Guffey
Senior Member
 
Join Date: July 18, 2008
Posts: 2,521
I have small base dies, I have RCBS BAR die sets, I can measure the diameter of a tapper, not a problem but distinguishing the difference between a case that has been sized with a small base die and a full length sizer die is not easy, then again, it goes back to “Who can measure the dimensions of a chamber?” I have blind end hole micrometers, I have blind hole transfers (calipers-inside and outside), old, very old, some made before 1900, nice to have, not necessary.

F. Guffey
F. Guffey is offline  
 
Page generated in 0.04651 seconds with 7 queries