Thread: .22lr 1918 bar
View Single Post
Old January 26, 2013, 02:39 PM   #2
defcon
Senior Member
 
Join Date: July 24, 2012
Location: Los Angeles
Posts: 154
Latest progress on the .22LR 1918 BAR using a Marlin 795

Finished JB welding the brass coupling. Just cured last night so its nice and tight. Just have to paint the brass piping flat black and then I'm off to the range tomorrow for test fires.

Why did I use brass piping? Because the 795 barrel was too short and I wanted to re-use the bipod so I bought brass piping with a 3/4 inner diameter that easily slips over the 795 barrel. Used a couple of couplings to mate 3 pipes together. Also found a threaded piece that can simulate a flash hider.



_MG_5468 by defconskylude, on Flickr


_MG_5469 by defconskylude, on Flickr

http://www.youtube.com/watch?v=fKnMLlfUheo
defcon is offline  
 
Page generated in 0.04849 seconds with 7 queries