View Single Post
Old January 26, 2013, 02:00 PM   #16
1911Tuner
Senior Member
 
Join Date: May 17, 2004
Location: NC Piedmont/Foothills
Posts: 605
re:

Quote:
you grind .015" off and the
round edge disappears.The profile is gone and you are left with the remains of
the flat part.prints,the half cock hook is shaped like an inverted
dipper,and the handle is round(.
I'll try again from a different direction.

Why would I do anything to the half-cock? It has nothing to do with the sear and hammer hook relationship. There's no reason to alter the half cock notch.

Quote:
You are equalizing the hooks' length .to .025" and I take that to mean bothhooks have the same distance to the body.
Right. One was longer than the other, so I laid a feeler gauge under the hooks and made them both the same length by cutting the tips flush with the gauge.
__________________
If your front porch collapses and kills more than three dogs...You just might be a redneck
1911Tuner is offline  
 
Page generated in 0.04154 seconds with 7 queries