View Single Post
Old January 25, 2013, 10:01 PM   #1
BerdanSS
Senior Member
 
Join Date: April 3, 2011
Location: to close to other houses
Posts: 1,003
Winchester stocks and model?

In bad need of a Winchester 1400 forearm (and stock so they match). My forearm cracked, looks like it may have been heavily sanded inside for some reason by the original owner and it didn't fit very tight. The op-rod cracked it while shooting skeet. I can't find anyplace that has them both...only found one place that has the buttstock. But no 12 ga forearms (or any for that matter). Would like to put something a little nicer on it maybe....like walnut or something. Anyone have ideas?

Also I don't know if I have the 1400 or 1400 MKII, Not sure if it matters as far as parts fitting. Mine is a late 80s early 90s manufacture. Has a vent rib barrel and more modern (and less cheesy than the old "scrolled" ones) checkered birch stocks. Would it say MKII someplace if it was, or can you tell just by looking at it?

Here she is:
BerdanSS is offline  
 
Page generated in 0.04606 seconds with 7 queries