View Single Post
Old January 25, 2013, 07:48 PM   #14
BigJimP
Senior Member
 
Join Date: February 23, 2005
Posts: 11,409
I would just stay with the peg-board and dowel rod concepts ....and for shorter or smaller handguns ...put trigger area over one rod ...and have a pair of dowel rods - one above the barrel & one below - so it will rest in between - so the rod captures the front end of the gun.

Some may rest on top dowel ...some on lower dowel ...maybe angle the nose of the gun a little up or down - depending on the look you want - and where the specific gun balances.
BigJimP is offline  
 
Page generated in 0.04199 seconds with 7 queries