View Single Post
Old January 23, 2013, 10:08 PM   #1
cogito
Member
 
Join Date: October 16, 2012
Location: Mid-Western State
Posts: 37
slide not locking with new mag -- dremel it?

Howdie,

I just bought some Pachmayr mags for my Sig P226. They feed without issue, but the slide doesn't lock after the first round.

Looking at the mag, the metal gap where the slide lock would hit is a bit narrow as is the corresponding place on the follower.

So, I presume I could just open it up a bit with a dremel. Any advice?
cogito is offline  
 
Page generated in 0.04138 seconds with 7 queries