View Single Post
Old January 23, 2013, 12:25 PM   #10
mehavey
Senior Member
 
Join Date: June 17, 2010
Location: Virginia
Posts: 3,013
I saw no pressure signs on the primer (no obvious cratering, edges still soft, etc), nor did I see
ejector slot burnishing on the case head.... AND you did not have sticky bolt lift.
I doubt you have a pressure problem.

Instead I suspect rough/possibly oblong-ish chamber-wall-to-case fit.

TEST: Polish the he$$ out of a loaded case -- make it absolutely shine and slicker than glass.
Might even rub a bit of nose oil on it before chambering.

Fire, and see if you still have an extraction issue.

Last edited by mehavey; January 23, 2013 at 05:13 PM.
mehavey is online now  
 
Page generated in 0.04345 seconds with 7 queries