View Single Post
Old January 22, 2013, 08:06 PM   #4
Pahoo
Senior Member
 
Join Date: February 16, 2006
Location: IOWA
Posts: 5,633
Single-line cutter recommended.

Quote:
There are spacers as well as multi-line cutters, designed to make the job look even and keep the lines parallel.
If you decide to do this work on your piece, I'd suggest a single line cutter and work slowly. If you go with a multi-line cutter, you wil have to define and match, your existing spacing and will have less control. Once you start, you will see what I mean. ....

Be Safe !!!
__________________
'Fundamental truths' are easy to recognize because they are verified daily through simple observation and thus, require no testing.
Pahoo is offline  
 
Page generated in 0.04627 seconds with 7 queries