View Single Post
Old January 22, 2013, 04:56 PM   #1
Reich
Junior Member
 
Join Date: February 26, 2012
Posts: 8
Case dimention question

I just bought RCBS die set for .222 rem. After trimming and sending the case through the decap size die all dimentions are perfect except neck diameter. All the Materal I read so far says it should be .253, but I keep ending up with .245. Not only is it a pain to seat the bullets,but I am worried about pressure problems. Am I good to run with these cases?

Reich
Reich is offline  
 
Page generated in 0.04270 seconds with 7 queries