View Single Post
Old January 22, 2013, 10:41 AM   #4
Michfab
Junior Member
 
Join Date: January 21, 2013
Posts: 6
Barrel length is 7.5 or 7.75 depending on where you measure from. The nipples are interchangable with my Remington Pietta. The twist is 1/3rd in
7.5" or roughly 1 in 22" using a cleaning rod. May not be the best way to check. If someone removed all the marks they did a masterful job, there is no evidence of it, or tool/file marks. It's had some use cause the cylinder shows a wear ring, and the edges of the the cylinder notches are pretty rounded. Timing is off as well. It has 4 screws in the frame so I think it can accept a shoulder stock. Any information would be appreciated. I just love the way if feels and looks.
Attached Images
File Type: jpg 2013-01-22_09-34-20_39.jpg (71.9 KB, 56 views)
File Type: jpg 2013-01-22_09-34-29_476.jpg (93.2 KB, 48 views)
File Type: jpg 2013-01-22_09-35-47_241.jpg (251.9 KB, 48 views)

Last edited by Michfab; January 22, 2013 at 10:49 AM.
Michfab is offline  
 
Page generated in 0.04522 seconds with 8 queries