View Single Post
Old January 21, 2013, 04:52 PM   #9
techrecruit
Junior Member
 
Join Date: January 21, 2013
Posts: 3
similar boat

I'm new to reloading as well and just now starting to use the press but am working on a brass preparation project right now and not fully loading off of it.

While depriming and sizing a ton of 9mm brass i had several parts just fly apart on me. For the life of me I can't figure out where they go. I know one end of the spring goes on a plate by the shell plate but not sure how everything else goes and also if i've actually broke a part, missing a part, etc...

Can someone post a good picture of what it's supposed to look like (up close). Couldn't find anything up close online.
See my pictures for reference of parts I found.
Attached Images
File Type: jpg parts that flew off.jpg (239.8 KB, 16 views)
File Type: jpg LocknLoad press.jpg (91.4 KB, 15 views)
File Type: jpg IMG_3595.jpg (118.4 KB, 16 views)
techrecruit is offline  
 
Page generated in 0.04721 seconds with 8 queries